2024 Gen 3.5 Raptor Accessories

The Gen 3.5 Front Tow Hook License Plate Mount hangs your front plate off the factory tow hooks. No drilling into the bumper, no adhesive, and it comes off as easily as it went on. There is also a universal front license plate mount kit and, for 2021-2023 trucks, a rear license plate backer.

The Active Suspension Control Module Guard shields the module that manages the truck's adaptive dampers. It is an expensive part sitting somewhere exposed, and the guard costs a fraction of replacing it.

• Adapt-A-Panel truck bed panel organizer kit for the 2024 F-150 Raptor.
• Behind rear seat panel kit for 2021+ Raptors.
• Off-road seat back panel kits — one with recovery gear, one with shovel, hammer and fire extinguisher.
• PACKOUT small truck bed mount for Milwaukee PACKOUT boxes.

Billet stubby antenna kits in 1/4-20 and M6 thread — the factory mast is the first thing to catch a branch. Third brake light antenna mount by Bullet Proof Diesel for running a whip. Mac's Custom Tie-Downs 35" to 40" Y-strap with twisted snap hooks for holding a spare down properly.

Does the tow hook plate mount require drilling?

No. It attaches to the factory front tow hooks and comes off without leaving a mark on the bumper.

Will Gen 3 accessories fit a Gen 3.5 truck?

Many interior and bed parts carry over. Anything that touches the front bumper generally does not — the 2024+ trucks use a modular bumper. Check each product page.

Why do I need a control module guard?

Because the active suspension control module sits where road debris and trail damage can reach it, and it is not a cheap part to replace.

Which antenna thread do I need?

Ford applications are typically 1/4-20; some newer vehicles use M6. Both are listed. If unsure, unscrew your factory mast and check.

All Gen 3.5 Raptor Parts · Gen 3.5 Light Mounts · Gen 3.5 GPS Mounts · Gen 3 Accessories · License Plate Mounts · Sensor & Module Protection