2025+ Ram RHO Rear Suspension Arm Kit - Billet Aluminum

• 2 FMI billet aluminum rear upper arms with spacers and hardware
• 2 FMI billet aluminum rear lower arms with spacers and hardware

This kit does not include a panhard bar upgrade.

The RHO's rear axle is located by four trailing arms. The lower arms push the truck forward and hold the axle under braking. The upper arms stop the axle from twisting and hold pinion angle.

A rubber-bushed link deflects a little every time load goes through it. A uniball pivot does not, so the axle stays where the arms put it. Replacing all four at once means none of the trailing arms are left as the soft point.

• Billet aluminum upper and lower arms.
• 1" FK uniballs at the pivots.
• 17-4 stainless steel heim spacers, custom machined to fit the stock mount locations.
• Urethane wobble stopper at the front mounts to keep the arms in alignment.
• Aluminum ball post on the upper arm for the suspension travel sensor, so the truck continues to work correctly.

Fits the 2025 and newer Ram 1500 RHO rear suspension, in the factory upper and lower arm mount locations.

The panhard bar is not part of this kit.

Three options: raw billet aluminum, black anodize and blue anodized.

What does this kit replace?

Both rear upper arms and both rear lower arms. It does not include a panhard bar.

Will the suspension travel sensor still work?

Yes. The upper arm carries an aluminum ball post for the factory suspension travel sensor so the truck works correctly.

What joints does it use?

1" FK uniballs, located in the stock mounts by custom machined 17-4 stainless steel spacers.

Is hardware included?

Yes. Each arm comes with its spacers and hardware.

What finishes are available?

Raw billet aluminum, black anodize or blue anodized.