2024+ Ranger Raptor Lower Arm Rear Pivot Reinforcement Brackets

The front lower control arm pivots on two mounts. When a front tire hits something hard, the load drives the arm rearward, and the rear mount takes a large share of it. On the Ranger Raptor, that rear mount is where the arm is prone to bending.

A bent mount moves the pivot point, and once the pivot moves the alignment goes with it. These brackets strengthen the rear mount so it resists bending on hard hits and keeps the lower arm's alignment stable.

• Strengthens the weak point at the rear mounts of the lower control arm
• Helps prevent the rear mounts from bending on hard hits
• Reinforces and stabilizes lower control arm alignment
• MIG welded for extra strength
• Powder coated in hammer black textured finish
• Bolt-on, uses factory hardware, no modifications needed

Fits the Ford Ranger Raptor, 2024 and newer.

Works with the stock front lower arms and with fabricated lower control arms for the Ranger Raptor.

Bolt-on, using the factory hardware, with no modifications needed.

After installation, have the truck realigned so you do not end up with poor tire wear at the front.

What problem do these fix?

The rear mount of the front lower arm is prone to bending under heavy front wheel impacts. The brackets strengthen that mount and keep the arm's alignment stable.

Do they work with aftermarket lower arms?

They work with both the stock lower arms and fabricated lower control arms for the Ranger Raptor.

Do I need to cut or drill anything?

No. The kit is bolt-on, uses factory hardware and needs no modifications.

Do I need an alignment afterwards?

Yes. Get the truck realigned once the brackets are installed to avoid poor front tire wear.