2010-2014 Gen 1 Raptor Fabricated Lower Control Arms - Stock Width

• 1 right side lower fabricated arm with installed FK uniballs
• 1 left side lower fabricated arm with installed FK uniballs
• 1 kit of 17-4 stainless spacers for the uniballs at the wheel and the frame
• 2 12-point 5/8" bolts for the lower uniball at the spindle

Reuse the factory A-arm mounting bolts at the frame, or use upgraded bolts if you also have frame support plate kits added at the lower A-arm mounts.

The lower arm carries most of the load at the front wheel: the coil-over sits on it, and every hit goes through it into the frame. It is also where future upgrades mount, from bypass shocks to bump stops and sway bars.

These arms use a 1.5" uniball at the spindle connection and 1" uniballs at the frame for strength and control. Billet machined steering stops are welded into the core of each arm and geometry-matched to the spindles, so the stops work with the spindle to protect your steering rack. And because the bypass shock mounts, sway bar tabs and bump stop plate are already built in, the arms are ready for the next stage of the build.

• 4130 material, MIG welded and fixture built for consistent fit and quality
• FK uniballs: 1.5" at the spindle, 1" at the frame
• Billet machined steering stops welded into the core of the arm, geometry-matched to the spindles
• All mounting spacers machined from 17-4 stainless
• Built-in bypass shock mounts and sway bar mounting tabs
• Bump stop plate welded on
• Final powder coat finish

• 3" bypass shock: add a 3" bypass to the truck with the add-on upper shock mount kit and special layout 3" shock.
• Front bump stops: our weld-on front bump stop kit can be added at any time. The arms come with the bump stop plate already welded on.
• Tunable sway bar: the Raptor front sway bar kit works with these arms and can be added at any time. It uses custom bent sway bar arms and either a 1" or 1.25" diameter sway bar, so you can tune the feel to your liking.

These arms will not work with the factory sway bar.

Fits the Gen 1 Ford F-150 Raptor, model years 2010, 2011, 2012, 2013 and 2014. Stock width.

• Works with the stock factory coil-over shock or aftermarket stock-replacement coil-over shocks
• Works with the stock factory spindle / upright
• Not compatible with the factory sway bar

Can I keep my stock shocks?

Yes. The arms work with the stock factory coil-over shock or any aftermarket stock-replacement coil-over.

Do they work with the factory spindle?

Yes. They work with the stock factory spindle / upright, using a 1.5" uniball at the spindle connection.

Will my factory sway bar still fit?

No. These arms will not work with the factory sway bar. Our tunable sway bar kit mounts to the tabs built into the arms.

Can I add bypass shocks later?

Yes. The arms have built-in bypass shock mounts. A 3" bypass can be added with the add-on upper shock mount kit and special layout 3" shock.

Do I need new frame bolts?

No. Reuse the factory A-arm mounting bolts at the frame. If you also have frame support plate kits at the lower A-arm mounts, you can use upgraded bolts.

What finish are they?

A final powder coat.